Top

A Simple Tool Stand

Thanks to Bob at I Like To Make Stuff, I was inspired check off a project I’ve been putting off for a long time.  I needed a rolling cart to hold my miter saw.  Now, I can push it out of the way when I don’t need it.  Eventually, the cart will roll into a slot in my toolbench, which would convert that into a miter station.  If I’m working with extra-long material, I can easily roll it out and make easy use of it.  But for now, the saw is sitting on this simple stand.  I made the height of the bed the same height as my table saw.  This height will be standard throughout my shop so I can use all surfaces as support.

Boards CutShop SelfieSimple Tool Stand

, , , ,

No comments yet.

Leave a Reply